ISO 17484-1:2014
2014-06
ISO 17484-1:2014
Résumé
ISO 17484-1:2014 specifies the general requirements and the performance requirements for multilayer pipe systems based on pipes, fittings and their joints intended to be used for gas supply within buildings.
PE-X and PE pipes composed of one stress-designed layer, adhesive and a barrier layer are also covered by ISO 17484-1:2014.
ISO 17484-1:2014 gives guidance for the design of piping systems consisting of multilayer pipes based on thermoplastics, for which at least 60 % of the wall thickness is polymeric material. Polymeric materials intended for stress-designed layers and all inner layers are required to be polyethylene (PE) and/or crosslinked polyethylene (PE-X) in accordance with Annex A of ISO 17484-1:2014.
ISO 17484-1:2014 applies to systems that operate at temperatures of −20 °C up to +60 °C.
For the purpose of ISO 17484-1:2014, crosslinked polyethylene (PE-X) and adhesive layers are considered as thermoplastic materials.
For sizes greater than 63 mm the requirements of ISO 18225 have to be fulfilled in addition.
ISO 17484-1:2014 is applicable for piping systems used in buildings to supply gas with a maximum operating pressure up to and including 500 kPa (5 bar).
ISO 17484-1:2014 applies to the following fuels:
- Category D gaseous fuel: natural gas;
- Category E gaseous fuel: LPG vapour, and natural gas or LPG vapour.
Cycle de vie
-
Précédemment
AnnuléeISO 17484-1:2006
AnnuléeISO 17484-1:2006/Cor 1:2008
-
Actuellement
PubliéeISO 17484-1:2014
Les normes ISO sont réexaminées tous les cinq ans
Stade: 90.20 (En cours d'examen)
