Reference number
ISO 10985:2009
© ISO 2024
ISO 10985:2009
Caps made of aluminium-plastics combinations for infusion bottles and injection vials — Requirements and test methods
Edition 3
2009-02
Withdrawn
Withdrawn (Edition 3, 2009)

Abstract

ISO 10985:2009 specifies general requirements and test methods for caps made of aluminium-plastics combinations in accordance with ISO 8536-7 or ISO 8362-6 intended for use respectively on infusion bottles as specified in ISO 8536-1 and/or injection bottles as specified in ISO 8362-1 and ISO 8362-4.

The purpose of ISO 10985:2009 is to specify caps that provide:

  • guarantee of originality of the closure up to the point of administration;
  • compression of the sealing element (rubber closure) on to the sealing surfaces of the infusion and/or injection bottles;
  • protection of the sealing element against soiling and mechanical damage;
  • simple and injury-free opening of the closure in order to expose the penetration area of the rubber closure and/or to permit total removal of the cap.

General information

  • Status
     : Withdrawn
    Publication date
     : 2009-02
    Stage
    : Withdrawal of International Standard [95.99]
  • Edition
     : 3
    Number of pages
     : 4
  • Technical Committee :
    ISO/TC 76
    ICS :
    11.040.20 
  • RSS updates

Life cycle

Sustainable Development Goals

This standard contributes to the following Sustainable Development Goal

3
Good Health and Well-being

Got a question?

Check out our Help and Support

  2. Store
  3. Standards catalogue
  4. ICS
  5. 11
  6. 11.040
  7. 11.040.20
  8. ISO 10985:2009